No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


ME60 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access 01

This is ME60 V800R010C10SPC500 Configuration Guide - LAN Access and MAN Access

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding an Interface to an MSTP Process - Share Link

Adding an Interface to an MSTP Process - Share Link

The link shared by multiple access rings is called a share link. The interfaces on the share link need to participate in Multiple Spanning Tree Protocol (MSTP) calculation in multiple access rings in different MSTP processes. After being added to MSTP processes, interfaces on the access links can participate in MSTP calculation.


Do as follows on the devices connected to access rings:


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the Ethernet interface participating in STP calculation is displayed.

    The interface specified in this command must be an interface on the share link between the devices configured with MSTP multi-process but not the interfaces that connect an access ring and a device.

    The following configuration can be configured both on a Layer 2 interface and a Layer 3 interface.

  3. Run stp binding process process-id [ to process-id ] link-share

    The interface is added to multiple MSTP processes to complete MSTP calculation.


    For a process with share links, you must run the stp enable command globally. For an interface that is added to the process in link-share mode, you must run the stp enable command in the interface view.

  4. Run commit

    The configuration is committed.

Updated: 2019-01-04

Document ID: EDOC1100059440

Views: 35277

Downloads: 27

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next