No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Feature Description - IP Multicast 01

This is ME60 V800R010C10SPC500 Feature Description - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multicast Program Join

Multicast Program Join

Multicast program join requires the user to be online and a member of a multicast group. In user-side multicast, only the Point-to-Point Protocol over Ethernet (PPPoE) access and IP over Ethernet (IPoE) access modes are supported, and only session-based replication is supported. As shown in Figure 10-2, a set top box (STB) user sends an IGMP Report message to join an IPTV multicast program. Most implementation processes are similar in PPPoE and IPoE access modes. See Table 10-2 for the differences between the processes.

NOTE:

Session-based multicast replication is used in the following illustration of the multicast program join process. Multicast program join processes of other multicast replication modes are similar to that of session-based multicast replication.

Figure 10-2 Multicast program join

Accessing the Internet through PPPoE or IPoE is a prerequisite for users to join multicast programs. Figure 10-3 illustrates the procedures of multicast program join, and Table 10-4 describes each procedure.

Figure 10-3 Multicast program join process
Table 10-4 Key actions in each multicast program join step

Step

Device

Key Action

STB

To join a multicast program after going online, an STB sends to an IGMP-capable BRAS an IGMP Report message of a multicast program. Upon receipt of the message, the BRAS identifies the user and the multicast program that the user wants to join.

BRAS

The BRAS creates a multicast forwarding entry for the STB. In this entry, the downstream interface is the interface that connects to the STB. If it is the first time that a BRAS creates a multicast forwarding entry for the STB, the BRAS sends a Protocol Independent Multicast (PIM) Join message to the rendezvous point (RP) or the source's designated router (DR).

RP/source's DR

After receiving the PIM Join message, the RP or the source's DR generates a multicast forwarding entry for the STB. In this entry, the downstream interface is the interface that receives the PIM Join message. Then, the STB successfully joins the multicast group, and the RP or source's DR can send the multicast traffic to the STB.

Source

The multicast source sends multicast traffic to the RP or the source's DR.

RP/source's DR

The RP or source's DR replicates multicast traffic to the BRAS.

BRAS

The BRAS replicates the multicast traffic it receives to the STB by session based on the multicast forwarding entry. The STB user can then watch the program.

BRAS

To determine whether any members remain in the multicast group, the BRAS periodically sends an IGMP Query message to the STB. If no members remain, the BRAS tears down the group.

STB

Upon receipt of the IGMP Query message, the STB responds with an IGMP Report message to keep the multicast program active.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059456

Views: 10477

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next