No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Feature Description - IP Multicast 01

This is ME60 V800R010C10SPC500 Feature Description - IP Multicast
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PIM-SSM Intra-domain

PIM-SSM Intra-domain

Both Protocol Independent Multicast-Source-Specific Multicast (PIM-SSM) and PIM-SM are for use on large-scale networks where group members are sparsely distributed. Unlike PIM-SM, PIM-SSM can be used in scenarios in which users know the multicast source location before they join a specific group and send requests to specific sources for multicast data. This section describes PIM-SSM intra-domain networking.

Multicast services are deployed on the large-scale network shown in Figure 4-45. An IGP has been deployed, and each network segment route is reachable. Group members are sparsely distributed on the network. User hosts on the network want to send Join messages directly to specific multicast sources and receive VoD information.

Figure 4-45 PIM-SSM intra-domain

Implementation Solution

On the network shown in Figure 4-45, Hosts A and B are multicast information receivers, each located on a different leaf network. The hosts receive VoD information in multicast mode. PIM-SSM is used throughout the PIM domain. Device B is connected to multicast source S1. Device A is connected to multicast source S2. Device C is connected to Host A. Devices E and F are connected to Host B.

Network configuration details are as follows:
  • PIM-SSM is enabled on all ME device interfaces.

    NOTE:

    A receiver in a PIM-SSM scenario can send a Join message directly to a specific multicast source. A shortest path tree (SPT) is established between the multicast source and receiver, not requiring the network to maintain Rendezvous Points (RPs).

  • IGMP runs between Device C and Host A, between Device E and Host B, and between Device F and Host B.

    When configuring IGMP on ME device interfaces, ensure that interface parameters are consistent. All ME devices connected to the same network must run the same IGMP version (IGMPv2 is recommended) and be configured with the same interface parameter values, such as the Query timer value and hold time of memberships. If the IGMP versions or interface parameters are different, IGMP group memberships are inconsistent on different ME devices.

  • Host A can send Join messages to S1. Host B can send Join messages to S2. Information sent by these multicast sources can reach user hosts.

    NOTE:

    Configuring interfaces on network edge devices to statically join all multicast groups is recommended to increase the speed for changing channels and to provide a stable viewing environment for users.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059456

Views: 11745

Downloads: 13

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next