No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Feature Description - IP Multicast 01

This is ME60 V800R010C10SPC500 Feature Description - IP Multicast

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for MSDP

Application Scenarios for MSDP

Inter-Domain Multicast

Figure 5-3 shows an inter-domain multicast application.
  • An MSDP peer relationship is set up between rendezvous points (RPs) in two different PIM-SM domains. Multicast source information can then be shared between the two domains.

  • After multicast data reaches RP 1 (the source's RP), RP 1 sends a source active (SA) message that carries the multicast source information to RP 2.

  • RP 2 initiates a shortest path tree (SPT) setup request to the source.

  • RP 2 forwards the multicast data to the receiver in the local domain.

  • After Receiver receives the multicast data, it independently determines whether to initiate an SPT switchover.

Figure 5-3 Inter-domain multicast within an AS

Anycast-RP

Figure 5-4 shows an Anycast-RP application.
  • Device 1 and Device 2 function as RPs and establish an MSDP peer relationship between each other.

  • Intra-domain multicast is performed using this MSDP peer relationship. A receiver sends a Join message to the nearest RP to set up a rendezvous point tree (RPT).

  • The multicast source registers with the nearest RP. RPs exchange SA messages to share the multicast source information.

  • Each RP joins an SPT with the source's DR at the root.

  • After receiving the multicast data, the receiver decides whether to initiate an SPT switchover.

Figure 5-4 Anycast-RP

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059456

Views: 13837

Downloads: 13

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next