No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Feature Description - WAN Access 01

This is ME60 V800R010C10SPC500 Feature Description - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPFv3-BGP Association

OSPFv3-BGP Association

When a new device is deployed on a network or a device is restarted, network traffic may be lost during BGP route convergence because IGP routes converge more quickly than BGP routes. OSPFv3-BGP association can address this problem.

After a device on a BGP network recovers from a fault, BGP convergence is performed again and packet loss may occur during the convergence.

In Figure 7-8, traffic from Device A to Device D through Device C traverses a BGP network.

Figure 7-8 Traffic traversing a BGP network

If Device C fails, traffic is switched to Device B after rerouting. Packets are lost when Device C recovers.

Because OSPFv3 route convergence is faster than BGP route convergence, OSPFv3 convergence is complete whereas BGP route convergence is still going on when Device C recovers. The next hop of the route from Device A to Device D is Device C, which, however, does not know the route to Device D since BGP convergence on Device C is not complete.

Therefore, Device C discards the packets destined for Device D after receiving them from Device A, as shown in Figure 7-9.

Figure 7-9 Packet loss during a device restart without OSPFv3-BGP association

OSPFv3-BGP Association Process

When a device with OSPFv3-BGP association restarts, the device sets the weight to the largest value (65535) in LSAs, instructing other OSPFv3 routers not to use it as a transit router for data forwarding. BGP routes, however, can still reach the device.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059473

Views: 14427

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next