No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Feature Description - WAN Access 01

This is ME60 V800R010C10SPC500 Feature Description - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BGP Auto FRR

BGP Auto FRR

As a protection measure against faults over links, BGP Auto Fast Reroute (FRR) is applicable to networks with primary and backup links. With BGP Auto FRR, traffic can be switched between two BGP peers or next hops within sub-seconds.

With BGP Auto FRR, if a peer has multiple routes with the same prefix that are learned from different peers, the peer uses the optimal route as the primary link to forward packets and the less optimal route as a backup link. If the primary link fails, the peer rapidly notifies other peers that the BGP route has become unreachable and then switches traffic from the primary link to the backup link.

Usage Scenario

On the network shown in Figure 9-29, Device Y advertises a learned BGP route to Device X2 and Device X3 in AS 100; Device X2 and Device X3 then advertise the BGP route to Device X1 through RR. Therefore, Device X1 receives two routes whose next hops are Device X2 and Device X3 respectively. Then, Device X1 selects a route based on a configured routing policy. Assume that the route sent by Device X2 (Link A) is preferred. The route sent by Device X3 (Link B) then functions as a backup link.

Figure 9-29 Networking for BGP Auto FRR

If a node along Link A fails or faults occur on Link A, the next hop of the route from Device X1 to Device X2 becomes unavailable. If BGP Auto FRR is enabled on Device X1, the forwarding plane then quickly switches to Link B the traffic from Device X1 to Device Y, which ensures uninterrupted traffic transmission. In addition, Device X1 reselects the route sent by Device X3 based on the forwarding prefixes and then updates the FIB table.

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059473

Views: 16007

Downloads: 10

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next