No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

ME60 V800R010C10SPC500 Feature Description - WAN Access 01

This is ME60 V800R010C10SPC500 Feature Description - WAN Access
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RIPng Packet Format

RIPng Packet Format

A RIPng packet is composed of a header and multiple route table entries (RTEs). In a RIPng packet, the maximum number of RTEs is determined by the maximum transmission unit (MTU) of an interface.

Figure 5-1 shows the basic format of a RIPng packet.

Figure 5-1 RIPng packet format

A RIPng packet contains two types of RTEs:

  • Next hop RTE: It defines the IPv6 address of the next hop and is located before a group of IPv6-prefix RTEs that have the same next hop. The Metric field of a next hop RTE is always 0xFF.

  • IPv6-prefix RTE: It describes the destination IPv6 address and the cost in the RIPng routing table and is located after a next hop RTE. A next hop RTE can be followed by multiple different IPv6-prefix RTEs.

Figure 5-2 shows the format of a next hop RTE.

Figure 5-2 Format of the next hop RTE

Figure 5-3 shows the format of an IPv6-prefix RTE.

Figure 5-3 Format of the IPv6-prefix RTE

Translation
Download
Updated: 2019-01-04

Document ID: EDOC1100059473

Views: 15711

Downloads: 10

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next