No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


SUN2000-(3KTL-10KTL) User Manual

This document describes the SUN2000-3KTL-M0, SUN2000-4KTL-M0, SUN2000-5KTL-M0, SUN2000-6KTL-M0, SUN2000-8KTL-M0, SUN2000-10KTL-M0, and SUN2000-12KTL-M0 in terms of their installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074467, 01074295, 01074300, 01074301, 01074302, 01074306, 01074311, 01074314, 01074315, 01074316, 01074320
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Powering On the System

Powering On the System


Before turning on the AC switch between the SUN2000 and the power grid, use a multimeter set to the AC position to check that the AC voltage is within the specified range.


  1. Turn on the AC switch between the SUN2000 and the power grid.

    If you perform 2 before 1, the SUN2000 reports a Grid Loss alarm. The SUN2000 starts normally only after the fault is automatically rectified.

  2. Set the DC SWITCH at the bottom of the SUN2000 to the ON position.
Updated: 2019-05-31

Document ID: EDOC1100059932

Views: 2759

Downloads: 213

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next