No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

SUN2000-(3KTL-10KTL) User Manual

This document describes the SUN2000-3KTL-M0, SUN2000-4KTL-M0, SUN2000-5KTL-M0, SUN2000-6KTL-M0, SUN2000-8KTL-M0, SUN2000-10KTL-M0, and SUN2000-12KTL-M0 in terms of their installation, electrical connections, commissioning, maintenance, and troubleshooting. BOM number: 01074467, 01074295, 01074300, 01074301, 01074302, 01074306, 01074311, 01074314, 01074315, 01074316, 01074320
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Wall-mounted Installation

Wall-mounted Installation

Procedure

  1. Determine the installation positions for drilling holes, and mark the positions using a marker.
  2. Secure the mounting brackets.

    NOTE:

    M6x60 expansion bolts are delivered with the SUN2000. If the length and amount of the bolts do not meet installation requirements, prepare M6 stainless steel expansion bolts by yourself.

    Figure 4-7 Expansion bolt composition

    (1) Bolt

    (2) Nut

    (3) Spring washer

    (4) Flat washer

    (5) Expansion tube

    Avoid drilling holes in the utility pipes or cables attached to the back of the wall.

    • To prevent dust inhalation or contact with eyes, wear safety goggles and an anti-dust respirator when drilling holes.
    • Clean up any dust in and around the holes using a vacuum cleaner and measure the distance between holes. If large hole tolerance exists, position and drill holes again.
    • After removing the bolt, spring washer, and flat washer, level the front of the expansion tube with the concrete wall. Otherwise, the mounting brackets will not stay steady on the concrete wall.
    • Partially loosen the nut, flat washer and spring washer of the two expansion bolts below.
    Figure 4-8 Installing the Mounting Bracket

  3. Install the SUN2000 onto the mounting bracket.
  4. Tighten nuts.

    Figure 4-9 Installing the SUN2000

  5. (Optional) Install the anti-theft lock.

    • Prepare an anti-theft lock suitable for the lock hole diameter (Ф8 mm) by yourself.
    • An outdoor waterproof lock is recommended.
    • Keep the key to the anti-theft lock safe.
    Figure 4-10 Installing the anti-theft lock

Download
Updated: 2019-05-31

Document ID: EDOC1100059932

Views: 2507

Downloads: 196

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next