No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionAccess 6.5 F5 Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Overview

Configuration Overview

Generally, the BIG-IP systems are deployed in two-node mode. Before configuring the BIG-IP system failover, ensure that the hardware models and software versions of the two BIG-IP systems are the same.

  • You need to complete basic configurations on both the active and standby systems. This section describes only the precautions for configuring the two-node systems and the configuration procedure after the basic configurations are complete.
  • For the V11 two-node systems, NTP needs to be configured on the two nodes.
  • If the virtual server needs to mirror connections and persistence, you are advised to configure NTP.
  • To view the version information, you can run the tmsh show/sys software command on the CLI or choose System > Configuration in the navigation pane on the web page.
Updated: 2019-05-30

Document ID: EDOC1100062218

Views: 622

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next