No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionAccess 6.5 F5 Configuration Guide 02

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Static Route

Configuring a Static Route

Procedure

  1. In the navigation pane on the left, choose Network > Routes.

  2. Click Add... in the upper right corner of the page.
  3. Set the related parameters as planned, as shown in Figure 3-12.

    Figure 3-12 Static route
    • Type: Set it to Default Gateway or Static Route based on site conditions.
    • Destination: Enter a destination network segment.
    • Netmask: Enter the mask of the destination network segment.
    • Resource: Set the gateway address.

  4. Click Finished as shown in Table 3-4.

    Table 3-4 Parameter

    Name

    Destination

    Netmask

    IP Address

    DEFAULT_ROUTE

    0.0.0.0

    0.0.0.0

    192.168.201.1

Download
Updated: 2019-05-30

Document ID: EDOC1100062218

Views: 578

Downloads: 19

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next