No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionAccess 6.5 F5 Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the IP Address of the BIG-IP Management Network Port on the LCD Panel

Setting the IP Address of the BIG-IP Management Network Port on the LCD Panel

Scenarios

After powering on the BIG-IP device, you need to set the IP address of the management network port on the LCD panel.

The default IP address is 192.168.1.245/24.

Procedure

Set IP addresses for management network ports using either of the following methods:

Using the LCD button

  1. Press the red X key on the LCD panel.
  2. Set the network address of the management network port.

    Press System > Management > Mgmt IP on the LCD panel.

  3. Set the subnet mask to be set for the management network port.

    Press System > Management > Mgmt Mask on the LCD panel.

  4. Choose the Commit Submission menu and click OK.

    1. Choose System > Management > Mgmt IP and set the management IP address of the management network port.
    2. Choose System > Management > Mgmt Mask and set the subnet mask of the management network port.
    3. Choose the Commit Submission menu and click OK.

Using the console port

  1. Connect the serial port of the PC and the serial console port on the F5 BIG-IP panel using a serial cable.
  2. Log in to the F5 BIG-IP through the HyperTerminal on the PC, enter config, and set the IP address of the management network port as prompted.

    The default username and password are root and default, respectively.

NOTE:

The management port can be used for device maintenance and management. You can connect this port with the maintenance VLAN of the service system.

  • The IP address of the management network port and that of the service system must be on different network segments to avoid address conflicts. Change the IP address of the network management port based on the IP address planning of the service network.
  • After changing the IP address using LCD buttons and clicking Commit, if the address fails to be changed (for example, the IP address becomes 0.0.0.0.), the IP address may conflict with the existing addresses in the system. In this case, restart the server, and then select the IP address or network segment to set the IP address of the management network port.
Download
Updated: 2019-05-30

Document ID: EDOC1100062218

Views: 1151

Downloads: 34

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next