No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionAccess 6.5 F5 Configuration Guide 02

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Active/Standby Switchover

Active/Standby Switchover


This section describes how to switch over the active and standby devices, that is, change the device status from ACTIVE to STANDBY.

  • ACTIVE: indicates the active device.
  • STANDBY: indicates the standby device.


  1. In the upper left corner on the page, click ACTIVE.
  2. Click Force to Standby.

  3. In the displayed dialog box, click OK, as shown in Figure 4-2. Perform the active/standby switchover.

    Figure 4-2 Displayed message

    You can determine whether the switchover is successful by checking the status in the upper left corner of WebUI.

Updated: 2019-05-30

Document ID: EDOC1100062218

Views: 583

Downloads: 19

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next