No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI CLOUD Stack 6.5.0 Alarm and Event Reference 04

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALM-2002501 Site Network Status Is Abnormal

ALM-2002501 Site Network Status Is Abnormal

Description

  • This alarm is generated when the network between site 1 and site 2 is disconnected or site 1 or site 2 is unavailable.
  • This alarm indicates a system fault or risk. You must locate and rectify the fault.

Attribute

Alarm ID

Alarm Severity

Auto Clear

2002501

Critical

Yes

Parameters

Parameter

Description

Resource name

Specifies the name of the device for which the alarm is generated.

Resource Type

MONITOR

Monitor type

Service monitoring

Host IP address

Indicates the IP address of the host.

Details

Data in recent periods

Threshold

Indicates the threshold for generating an alarm.

Impact on the System

The system is running on a single node, which results in reliability risks.

Possible Causes

  • The network between site 1 and site 2 is disconnected.
  • Site 1 or site 2 is powered off.
  • Site 1 or site 2 cannot communicate with both the peer site and site 3.

Handling Procedure

  1. Contact the administrator to check whether the network connections among site 1, site 2, and site 3 are normal and whether the services at these sites are running properly. After restoring network connections or services, go to 2.
  2. Wait for 3 minutes and check whether the alarm is automatically cleared.

    • If yes, no further action is required.
    • If no, go to 3.

  3. Contact technical support.

Reference

None

Translation
Download
Updated: 2019-08-30

Document ID: EDOC1100062365

Views: 34391

Downloads: 31

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next