No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


HUAWEI Firewall Comprehensive Configuration Examples

This document describes the application scenarios and configuration methods in typical projects of the firewall.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Typical Networking

Typical Networking

Figure 3-2 shows the typical networking of firewalls at the data center egress.

  • Core switches SW1 and SW2 are stacked; aggregation switches SW3 and SW4 are stacked. Firewalls are located between core switches and aggregation switches. They work in Layer 3 hot standby mode.
  • VRRP is configured on the interfaces connecting the firewalls to the upstream and downstream devices. The firewalls use the VRRP virtual IP addresses to communicate with the upstream and downstream devices.
  • Static routes are configured on the firewalls to guide traffic forwarding.
Figure 3-2  Typical networking of firewalls at the data center egress
Updated: 2019-01-26

Document ID: EDOC1100062972

Views: 18290

Downloads: 765

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next