No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionCloud 6.3.1.1 Troubleshooting Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Initializing the Faulty Node

Initializing the Faulty Node

After the service deployment system is installed, you need to initialize the faulty node.

Procedure

  1. Use PuTTY to log in to the faulty node as the root user. For details about how to view the faulty node, see 17.

    The default password is Changeme_123.

  2. Run the following command to create the /opt/pub/software directory:

    mkdir -p /opt/pub/software

  3. Use PuTTY to log in to the node deploying ManageOne as the root user.

    The default password is Changeme_123.
    NOTE:

    You can log in to the ManageOne deployment plane and choose Resource > Server to view the Deploy node.

    If a Deploy node is faulty, log in using the IP address of a normal Deploy node.

    If an application node is faulty, log in using the IP address of the Deploy01 node.

  4. Run the following command to clear the original signature information on the faulty node:

    > /root/.ssh/known_hosts

  5. Run the following command to copy the software package to the faulty node:

    scp /opt/pub/software/repository/Services/ServiceDeploy/DeployBaseAgent/DeployBaseAgent-version.zip root@IP address of the faulty node:/opt/pub/software

    When a message prompts you to confirm whether to connect to the faulty node, enter yes.

    Enter the password of the root user of the Deploy node as prompted.

    NOTE:

    In the preceding command, version indicates the DeployBaseAgent version number. Replace it with the latest version number.

  6. Use PuTTY to log in to the faulty node as the root user. For details about how to view the faulty node, see 17.

    The default password is Changeme_123.

  7. Run the following command to switch to the /opt/pub/software directory:

    cd /opt/pub/software

  8. Run the following command to decompress and initialize the software package:

    unzip -o DeployBaseAgent-version.zip -d baseagent

  9. Run the following command to initialize the faulty node:

    bash -x /opt/pub/software/baseagent/bootstrap.sh -ip IP address of the Deploy node

    NOTE:

    If the faulty node is a Deploy node, replace IP address of the Deploy node with the IP address of a normal node.

    If the faulty node is an application node, replace IP address of the Deploy node with the IP addresses of the two Deploy nodes.

  10. Run the following command to log out of the root user:

    exit

  11. About two minutes later, check the status of the initialized node on the service deployment system.

    1. Choose Resource > Server from the main menu.
    2. In the upper right corner of the Server page, select All, enter the IP address of the initialized node in the search box, and press Enter.

      If the node status is , the node is initialized successfully.

Translation
Download
Updated: 2019-08-16

Document ID: EDOC1100063248

Views: 25308

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next