Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ike peer
Function
The ike peer command creates an IKE peer and displays the IKE peer view.
The undo ike peer command deletes the specified IKE peer.
By default, no IKE peer is configured.
Parameters
| Parameter | Description | Value |
|---|---|---|
| peer-name | Specifies the name of an IKE peer. | The value is a string of 1 to 15 case-sensitive characters without question marks (?) and spaces. |
Usage Guidelines
Usage Scenario
You can run the ike peer command to enter the IKE peer view and then define all parameters for the IKE peer, including:
- Negotiation mode
- ID type
- NAT traversal
- Pre-shared key
- Remote address
- Peer name
Follow-up Procedure
Run the ike-peer command to reference the IKE peer.
