ap manufacturer-config
Parameters
Parameter |
Description |
Value |
|---|---|---|
ap-name ap-name |
Specifies the name of the AP, factory settings of which need to be restored. |
The AP name must already exist. |
ap-mac ap-mac |
Specifies the MAC address of the AP, factory settings of which need to be restored. |
The AP's MAC address must already exist. |
ap-id ap-id |
Specifies the ID of the AP, factory settings of which need to be restored. |
The AP ID must already exist. |
Usage Guidelines
When a configuration error occurs on the AP, you can run this command to clear AP configurations.
When an upstream device is connected to a central AP or an AP with two network ports through an Eth-Trunk, you need to enable one member interface of the Eth-Trunk and disable other member interfaces before restoring the factory settings of the AP by holding down Default or running the ap manufacturer-config command. Otherwise, loops and MAC address flapping occur, and the network connection fails.
