calibrate flexible-radio manual-recognize
Function
The calibrate flexible-radio manual-recognize command triggers identification of redundant radios.
Usage Guidelines
Usage Scenario
The network administrator can run this command to manually trigger identification of redundant radios, and can enable DFA if discovering that redundant radios exist on the network.
Prerequisites
Radio calibration has been enabled using the calibrate enable { auto [ interval interval-value [ start-time start-time ] ] | manual | schedule time time-value } command.
Precautions
This command only triggers identification of redundant radios but does not switch or disable identified redundant radios.
Radio scanning is required for identifying redundant radios, which may degrade wireless service experience.
Follow-up Procedure
After redundant radios are identified, you can run the display flexible-radio status command to check the status of the redundant radios.
