router-id (BGP)
Function
The router-id command configures a Router ID for the wireless access controller.
The undo router-id command deletes the Router ID configured for the wireless access controller.
By default, no BGP Router ID is configured, and the Router ID configured for the route management module through the router id command is used.
Parameters
| Parameter | Description | Value |
|---|---|---|
| ipv4-address | Specifies a Router ID. | It is in dotted decimal notation. |
Usage Guidelines
Usage Scenario
The router-id command is used to configure a Router ID for the wireless access controller. Each Router ID uniquely identifies one BGP wireless access controller in an AS.
Prerequisites
The bgp command is run to enable BGP.
Precautions
Changing or deleting a configured Router ID in the BGP view resets a BGP session.
By default, the wireless access controller that is not configured with any interface uses the Router ID of 0.0.0.0 assigned by routing management.
