Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
stopbits
Function
The stopbits command sets the stop bit of a user interface.
The undo stopbits command restores the default stop bit of a user interface.
By default, the stop bit is 1.
Parameters
| Parameter | Description | Value |
|---|---|---|
| 1.5 | Sets the stop bit to 1.5. | - |
| 1 | Sets the stop bit to 1. | - |
| 2 | Sets the stop bit to 2. | - |
Usage Guidelines
If the stop bit is 1, the corresponding data bit is 7 or 8.
If the stop bit is 1.5, the corresponding data bit is 5.
If the stop bit is 2, the corresponding data bit is 6, 7, or 8.
This function takes effect for only serial interfaces.
On the console user interface, the stop bit 1.5 is not supported.
