Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display transceiver diagnosis interface
Function
Using the display transceiver diagnosis interface command, you can view the diagnosis parameters of an optical transceiver.
Usage Guidelines
Before viewing the diagnosis parameters of an optical transceiver, make sure that the optical transceiver is an enhanced optical transceiver and has been installed on the device.
Example
# Display the diagnosis parameters of the optical transceiver installed in GigabitEthernet0/0/1.
<AC6605> display transceiver diagnosis interface gigabitethernet0/0/1 Port GigabitEthernet0/0/1 transceiver diagnostic information: Parameter Current Low Alarm High Alarm Type Value Threshold Threshold Status ------------- --------- --------- ---------- -------- TxPower(dBm) -4.64 0.00 0.00 abnormal RxPower(dBm) -4.37 33.00 0.00 abnormal Current(mA) 7.42 0.00 0.00 abnormal Temp.(C) 30.00 0.00 0.00 abnormal Voltage(V) 3.28 0.00 8.19 normal
Table 4-14 Description of the display transceiver diagnosis interface
command output
Item |
Description |
|---|---|
Parameter Type |
Parameter type.
|
Current Value |
Current value of a parameter. |
Low Alarm Threshold |
Lower alarm threshold of a parameter. |
High Alarm Threshold |
Upper alarm threshold of a parameter. |
Status |
Status of the optical transceiver, which can be normal or abnormal. |
