Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
radius-server detect-server timeout
Function
The radius-server detect-server timeout command configures the timeout period for RADIUS detection packets.
The undo radius-server detect-server timeout command restores the default settings.
By default, the timeout period for RADIUS detection packets is 3 seconds.
Usage Guidelines
Usage Scenario
After the automatic detection function is enabled using the radius-server testuser command, you can run the radius-server detect-server timeout command to adjust the timeout period for RADIUS detection packets based on the actual response rate of the RADIUS server.
Precautions
You are advised to set a timeout period for RADIUS detection
packets smaller than the automatic detection interval to prevent the
device from sending a detection packet again before completing processing
the response packet from the RADIUS server. If the actual timeout
period for RADIUS detection packets is larger than the automatic detection
interval, the smaller value is the timeout period, namely:
- For the RADIUS server in Down status, the smaller one between values configured using the radius-server detect-server timeout and radius-server detect-server interval commands is the timeout period for detection packets.
- For the RADIUS server in Up status, the smaller one between values configured using the radius-server detect-server timeout and radius-server detect-server up-server interval command is the timeout period for detection packets.
