sta-load-balance dynamic btm-fail-times
Function
The sta-load-balance dynamic btm-fail-times command sets the maximum number of attempts to migrate STAs in BTM mode.
The undo sta-load-balance dynamic btm-fail-times command restores the default maximum number of attempts to migrate STAs in BTM mode.
By default, the maximum number of attempts to migrate STAs in BTM mode is 5.
Format
sta-load-balance dynamic btm-fail-times btm-fail-times
undo sta-load-balance dynamic btm-fail-times
Usage Guidelines
Usage Scenario
The device preferentially uses the BTM mode to trigger STA migration to the target AP. Due to differences of STAs, some STAs can be successfully migrated in BTM mode after multiple attempts. You can run the sta-load-balance dynamic btm-fail-times command to set the maximum number of attempts to migrate STAs in BTM mode. If the number of attempts exceeds the specified value, the device attempts to migrate STAs in deauthentication mode.
Precautions
You are advised to retain the default value. If the success rate of STA migration in BTM mode is low, you can set a smaller value to improve the migration efficiency.
This command is valid only in sta-number mode.
