mac-address aging-time
Function
The mac-address aging-time command sets the aging time of dynamic MAC address entries.
The undo mac-address aging-time command restores the default aging time of dynamic MAC address entries.
By default, the aging time of dynamic MAC address entries is 300 seconds.
Usage Guidelines
Usage Scenario
The network topology changes frequently, and the wireless access controller will learn many MAC addresses. You can run the mac-address aging-time command to set a proper aging time for dynamic MAC address entries so that aged MAC address entries are deleted from the MAC address table. This reduces MAC address entries in the MAC address table.
The system starts an aging timer for each dynamic MAC address entry. If a dynamic MAC address entry is not updated within a certain period (twice the aging time), the entry is deleted. If the entry is updated within this period, the aging timer of this entry is reset. If the aging time is short, the wireless access controller is sensitive to network changes.
When setting the aging time of dynamic MAC address entries, follow these rules:
- Set a longer aging time on a stable network and a shorter aging time on an unstable network.
- The capacity of the MAC address table on a low end device is small; therefore, set a relatively short aging time on low end devices to save the MAC address table space.
Precautions
If the aging time is 0, dynamic MAC addresses will not be aged out. In this case, MAC address entries increase sharply and the MAC address table will be full quickly.
If you run the mac-address aging-time command multiple times, only the latest configuration takes effect.
Dynamic MAC address entries are lost after system restart. Static MAC address entries and blackhole MAC address entries are not aged or lost.
