vap-profile (local AC view)
Function
The vap-profile command binds a VAP profile to a local AC.
The undo vap-profile command unbinds a VAP profile from a local AC.
By default, no VAP profile is bound to a local AC.
Parameters
| Parameter | Description | Value |
|---|---|---|
| profile-name | Specifies the name of a VAP profile. |
The VAP profile must exist. |
| wlan wlan-id | Specifies the WLAN ID of the VAP profile. |
The value is an integer that ranges from 1 to 16. |
Usage Guidelines
Usage Scenario
Two AC types are defined: local AC and Navi AC.
- Run the navi-ac enable command to enable the Navi AC function. If the Navi AC function is disabled, the default AC type is local AC.
- Run the local-ac ac-id command to specify the AC ID and IP address of a local AC.
- Run the vap-profile (local AC view) command in the specified local AC view to bind the VAP profile to the local AC.
Precautions
A maximum of 16 VAP profiles can be bound to a local AC view.
A VAP profile bound to a local AC view cannot be deleted.
- A VAP profile cannot be repeatedly bound to a local AC view, and the WLAN ID of the VAP profile is unique.
The parameter wlan-id in this command must be set to the same as the parameter navi-wlan-id in the type service-navi navi-ac-id navi-ac-id navi-wlan-id navi-wlan-id command.
The service data forwarding mode can be set only to tunnel forwarding.
Example
# Enable the Navi AC function and bind a VAP profile to a local AC.
<AC6605> system-view [AC6605] wlan [AC6605-wlan-view] navi-ac enable [AC6605-wlan-view] navi-ac [AC6605-wlan-view-navi-ac] local-ac ac-id 1 ip-address 192.168.1.105 description LocalAC1 [AC6605-wlan-view-navi-local-ac-1] vap-profile auth wlan 2
