Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
default-cost (OSPFv3 Area View)
Function
The default-cost command specifies the cost of the default route that is sent to the stub area by OSPFv3.
The undo default-cost command restores the cost to the default value.
By default, the cost of the Type 3 default route transmitted to the stub area is 1.
Parameters
| Parameter | Description | Value |
|---|---|---|
| cost | Specifies the cost of the default route that is sent to the stub area by OSPFv3. | The value ranges from 0 to 16777214. By default, it is 1. |
Usage Guidelines
This command is applicable only to the ABR that is connected to the stub area.
Before setting the cost of the default route that is transmitted to the stub area by OSPFv3, you need to configure the local area as a stub area by using the stub command. You can use the default-cost command to specify the cost of the default route that is transmitted to the stub area by the ABR.
If multiple OSPFv3s are enabled, the command takes effect only on this process.
Related Topics
