source (BLE profile view)
Function
The source command sets the source IP address used by the AC to send packets to a location server.
The undo source command deletes the configured source IP address.
By default, the source IP address used by the AC to send packets to a location server is not configured, and the IP address of the route outbound interface is used as the source IP address.
Parameters
Parameter |
Description |
Value |
|---|---|---|
ip-address ip-address |
Specifies the source IPv4 address used by the AC to send packets to a location server. |
The value is in dotted decimal notation. |
ipv6-address ipv6-address |
Specifies the source IPv6 address used by the AC to send packets to a location server. |
The value is a 32-digit hexadecimal number, in the format X:X:X:X:X:X:X:X. |
Usage Guidelines
Usage Scenario
In Bluetooth location scenarios, after the source IP address used by the AC to send packets to a location server is configured using the source command, the packet sent from the AC to a location server carries this IP address as its source IP address.
Precautions
- Ensure that the AC IP address manually configured on a location server is the same as that configured using the source command.
- The source IP address must be a valid IP address existing on the device; otherwise, the configuration does not take effect.
- When the source (BLE profile view) and ble source commands are both executed, the function configured using the source (BLE profile view) command takes effect.
In wireless configuration synchronization scenarios, the Bluetooth location service does not allow the source IP address for an AC to send packets to a location server to be configured using the source (BLE profile view) command. To configure the source IP address, run the ble source command.
