No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
lldp message-transmission hold-multiplier (AP system profile view)

lldp message-transmission hold-multiplier (AP system profile view)

Function

The lldp message-transmission hold-multiplier command sets the hold time multiplier of device information stored on neighbors.

The undo lldp message-transmission hold-multiplier command restores the default hold time multiplier of device information stored on neighbors.

The default hold time multiplier is 4.

Format

lldp message-transmission hold-multiplier hold

undo lldp message-transmission hold-multiplier

Parameters

Parameter

Description

Value

hold

Specifies the hold time multiplier of device information stored on neighbors.

The value is an integer that ranges from 2 to 10.

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The time multiplier is used to calculate how long a packet can be saved on a neighboring node. After receiving an LLDP packet, a neighbor updates the aging time of the device information from the sender based on the TTL.

The storage time calculation formula is: TTL = Min (65535, (interval x hold)).

TTL is the device information storage time. It is the smaller value between 65535 and (interval x hold).

interval indicates the interval at which the device sends LLDP packets to neighbors. This parameter is set by the lldp message-transmission interval command. hold indicates the hold time multiplier of device information stored on neighbors.

After the LLDP function is disabled on the device, its neighbors wait until the TTL of the device information expires, and then delete the device information. This prevents network topology flapping.

Configuration Impact

The hold time multiplier of device information stored on neighbors must be set to a proper value.
  • A large value of delay prevents network topology flapping. However, if the value is too large, the device cannot notify neighbors of its status in a timely manner, and the NMS cannot discover the network topology changes in real time.
  • A small value of delay enables the NMS to discover topology change in time. However, if the value is too small, the neighbors update device information too frequently. This increases the load on the system and wastes resources.
  • The default value is recommended.

Example

# Set the hold time multiplier of RU information stored on neighbors to 5.

<Huawei> system-view
[Huawei] wlan 
[Huawei-wlan-view] ap-system-profile name ap-system1
[Huawei-wlan-ap-system-prof-ap-system1] lldp message-transmission hold-multiplier 5
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 201792

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next