No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
calibrate auto-txpower-select disable

calibrate auto-txpower-select disable


The calibrate auto-txpower-select disable command disables automatic transmit power selection.

The undo calibrate auto-txpower-select disable command enables automatic transmit power selection.

By default, automatic transmit power selection is enabled.


calibrate auto-txpower-select disable

undo calibrate auto-txpower-select disable




Radio interface view

Default Level

2: Configuration level

Usage Guidelines

Two power selection modes are available:
  • Automatic mode (enabling automatic transmit power selection): An AP automatically selects or adjusts the transmit power based on the WLAN radio environment, removing the need to specify AP power manually.
  • Fixed mode (disabling automatic transmit power selection): The transmit power must be manually specified.

If an AP needs radio calibration, automatic transmit power selection must be enabled.

For common Fat APs, to ensure the signal strength of the default SSID, automatic transmit power selection is disabled and the transmit power is fixed at 20 dBm when no country code is configured. You can configure the country code according to local laws and regulations and then enable automatic transmit power selection.


# Disable automatic transmit power selection.
<Huawei> system-view
[Huawei] interface Wlan-Radio 0/0/0
[Huawei-Wlan-Radio0/0/0] calibrate auto-txpower-select disable
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 199834

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next