No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
smart-roam disable

smart-roam disable


The smart-roam disable command disables smart roaming.

The undo smart-roam disable command enables smart roaming.

By default, smart roaming is enabled.

Only cloud APs support this command.


smart-roam disable

undo smart-roam disable




RRM profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

When STAs connected to an AP have weak signals, their network access rates are low. In this situation, if many low-rate STAs connect to the AP, air interface occupation time of other STAs is reduced. As a result, the AP throughput decreases, degrading user experience. To prevent this situation, configure forced logout of weak-signal STAs. When detecting that the SNR or access rate of a STA is lower than the specified threshold, the AP sends a Disassociation packet to the STA to force the STA offline so that the STA can reconnect to the WLAN.

Follow-up Procedure

Run the smart-roam roam-threshold { check-snr | check-rate } command to configure the trigger mode of smart roaming and the smart-roam roam-threshold { snr | rate } command to configure the smart roaming threshold. After that, APs forcibly disconnect STAs with SNR or access rate lower than the threshold.


# Enable smart roaming.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] rrm-profile name default
[Huawei-wlan-rrm-prof-default] undo smart-roam disable
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 248101

Downloads: 140

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next