No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
bfd bind peer-ip default-ip

bfd bind peer-ip default-ip


The bfd bind peer-ip default-ip command creates a BFD binding for detecting the physical status of a link.

The undo bfd session-name command deletes a specified BFD session and the created BFD binding.

By default, BFD binding is not created.


bfd session-name bind peer-ip default-ip interface interface-type interface-number [ source-ip ip-address ]

undo bfd session-name






Specifies the session name of BFD.

The value is a string of 1 to 15 characters without spaces.

peer-ip default-ip

Indicates the default multicast IP address that is bound to a BFD session.

By default, BFD uses the multicast IP address You can set the multicast IP address by running the default-ip-address command.

interface interface-type interface-number

Specifies the type and number of the interface bound to a BFD session.

  • interface-type specifies the interface type.

  • interface-number specifies the interface number.


source-ip ip-address

Indicates the source IP address carried in BFD packets. If the source IP address is not specified, the system searches the local routing table for an outbound interface from which the peer IP address can be reached. The IP address of this outbound interface is used as the source IP address of BFD packets sent by the local end. Generally, this parameter is not required.



System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If source-ip is specified, the URPF-enabled device does not incorrectly discard BFD packets. Ensure that the source IP address is correct. The system only checks whether the source IP address is valid (for example, it cannot be a multicast or broadcast address) without checking correctness.


If the IP address of an outbound interface is changed after a BFD session is configured, the source IP address of BFD packets is not updated.

After the bfd bind peer-ip default-ip command is executed, run the commit command to commit the configuration to make the configuration take effect.


# Create a BFD session named test, and then detect the one-hop link that is bound to the local interface GigabitEthernet0/0/1 through the default multicast IP address.

<Huawei> system-view
[Huawei] bfd test bind peer-ip default-ip interface gigabitethernet 0/0/1
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 201126

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next