No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display ftp-server

display ftp-server


The display ftp-server command displays FTP server parameter settings.


display ftp-server




All views

Default Level

1: Monitoring level

Usage Guidelines

You can run this command to display FTP server parameter settings.


# Display FTP server parameter settings.

<Huawei> display ftp-server
   FTP server is running
   Max user number                 15
   User count                      1
   Timeout value(in minute)        30
   Listening port                  21
   Acl number                      2010
   FTP server's source address
Table 2-28  Description of the display ftp-server command output



FTP server is running

The FTP server starts.

You can run the ftp server enable command to start the FTP server.

Max user number

Maximum number of users who can access the FTP server.

User count

Number of users who are accessing the FTP server.

Timeout value(in minute)

Idle timeout duration of FTP users.

You can run the ftp timeout command to set the idle timeout duration of FTP users.

Listening port

Number of the listening port on the FTP server. The default value is 21.

If the value is not 21, you can run the ftp server port command to configure the listening port number.

Acl number

Number of the ACL of the FTP server.

The default value is 0. You can run the ftp acl command to change the ACL number.

FTP server's source address

Source IP address for the FTP server to send packets. The default value is

You can run the ftp server-source command to configure the source IP address for the FTP server. Here, the source IP address is displayed. If a source interface is configured, this field displays "FTP server's source interface LoopBack0."

Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 209288

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next