No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
authentication ip-address in-accounting-start

authentication ip-address in-accounting-start


The authentication ip-address in-accounting-start command enables the function of carrying users' IP addresses in Accounting-Start packets.

The undo authentication ip-address in-accounting-start command disables the function of carrying users' IP addresses in Accounting-Start packets.

By default, the function of carrying users' IP addresses in Accounting-Start packets is disabled.


authentication ip-address in-accounting-start [ arp-delay ]

undo authentication ip-address in-accounting-start [ arp-delay ]






Permits ARP packets after Accounting-Start Response packets are received. By default, ARP packets are permitted after authentication succeeds.

This parameter is supported only in wireless scenarios.



Authentication profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The device reports access information and basic network information (IP address) of users through Accounting-Start packets. Therefore, the device needs to support carrying users' IP addresses in Accounting-Start packets.

For example, in the wireless scenario where MAC address-prioritized Portal authentication is enabled, you can configure the arp-delay parameter to enable the device to deny ARP packets before it receives Accounting-Start Response packets.


If the device cannot learn IP addresses of users, the device does not send Accounting-Start packets.

This command takes effect only for 802.1X authentication and MAC address authentication users. By default, Accounting-Start packets for Portal authentication carry users' IP addresses.

This command takes effect on both IPv4 and IPv6 users.


# Enable the function of carrying users' IP addresses in Accounting-Start packets.

<Huawei> system-view
[Huawei] authentication-profile name test 
[Huawei-authentication-profile-test] authentication ip-address in-accounting-start
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 194987

Downloads: 118

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next