No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
port trunk pvid vlan

port trunk pvid vlan


The port trunk pvid vlan command specifies the default VLAN for a trunk interface.

The undo port trunk pvid vlan command restores the default VLAN of a trunk interface to the default setting.

By default, VLAN 1 is the default VLAN of trunk interfaces.


port trunk pvid vlan vlan-id

undo port trunk pvid vlan






Specifies the default VLAN ID of a trunk interface.

The value is an integer that ranges from 1 to 4094.


GE interface view, Eth-Trunk interface view, XGE interface view, MultiGE interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

An interface may receive untagged and tagged frames, but the device processes only tagged frames. Therefore, the device adds a tag to each untagged frame received by an interface. The default VLAN ID of the interface can be added to untagged frames so that these frames are forwarded in the default VLAN.


The VLAN to be specified as the default VLAN has been created.

Follow-up Procedure

Add the trunk interface to the default VLAN.


The port trunk pvid vlan command only specifies the default VLAN of a trunk interface but does not add the trunk interface to the default VLAN. A trunk interface forwards frames with the default VLAN ID only after it is added to the default VLAN using the port trunk allow-pass vlan command.

If you run the port trunk pvid vlan command multiple times in the same interface view, only the latest configuration takes effect.


# Specify VLAN 5 as the default VLAN of GE0/0/1.

<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/1
[Huawei-GigabitEthernet0/0/1] port link-type trunk
[Huawei-GigabitEthernet0/0/1] port trunk pvid vlan 5
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 195052

Downloads: 118

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next