No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
radius-server dead-detect-condition by-server-ip

radius-server dead-detect-condition by-server-ip

Function

The radius-server dead-detect-condition by-server-ip command configures keepalive detection for RADIUS server based on the RADIUS server IP address.

The undo radius-server dead-detect-condition by-server-ip command restores the default setting.

By default, keepalive detection is performed for only RADIUS authentication server.

Format

radius-server dead-detect-condition by-server-ip

undo radius-server dead-detect-condition by-server-ip

Parameters

None

Views

System view

Default Level

3: Management level

Usage Guidelines

Usage Scenario

The device periodically sends authentication request packets to the RADIUS server in Down state. If the RADIUS server responds, the device sets the RADIUS authentication server status to Up. The device does not perform keepalive detection for RADIUS accounting servers in Down state. Instead, the device sets the RADIUS accounting server status to Up only when the server recovery time expires.

To allow the device to promptly detect the status of RADIUS accounting servers that are in Down state, run the radius-server dead-detect-condition by-server-ip command. After the command is executed, the device performs keepalive detection on RADIUS servers based on the RADIUS server IP address, so that the status of RADIUS accounting server is associated with the status of authentication server.

Precautions

After the radius-server dead-detect-condition by-server-ip command is executed, run the radius-server testuser command to configure automatic user detection.

When detecting the Down states of RADIUS authentication and accounting servers, the device counts the numbers of authentication and accounting request packets separately. After the radius-server dead-detect-condition by-server-ip command is executed, if the authentication and accounting servers sharing the same IP address are in the same VPN instance, the device accumulates the number of authentication and accounting packets sent by the servers. In addition, the status of RADIUS authentication server with the same IP address in the same VPN instance is updated.

Example

# Configure keepalive detection for RADIUS server based on RADIUS server IP address.

<Huawei> system-view
[Huawei] radius-server dead-detect-condition by-server-ip
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 203379

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next