No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display poe information

display poe information


The display poe information command displays PoE running information about the device.

Only the AP8082DN, AP8182DN, AP4050DN-E, AP4050DN-HD, AP7050DN-E, AD9431DN-24X, AD9430DN-24, and AD9430DN-12 support this command.


display poe information [ slot slot-id ]





slot slot-id

Displays the PoE state information about a device in a specified slot.

If this parameter is not specified, the PoE information about all device is displayed.

The value is an integer and the value range depends on the device configuration.


All views

Default Level

2: Configuration level

Usage Guidelines

This command displays information including the maximum output power set by the user, current power consumption, peak power consumption, and power management mode.


# Display the PoE running information about the device.

<Huawei> display poe information
PSE Information of slot 0:
    User Set Max Power(mW)     : 380000
    POE Power Supply(mW)       : 380000
    Available Total Power(mW)  : 371784
    Total Power Consumption(mW): 8216
    Power Peak Value(mW)       : 11284
    Power-Management Mode      : auto
    Power High Inrush          : disable
    Power AF Inrush            : disable
Table 4-46  Description of the display poe information command output



User Set Max Power(mW)

Maximum output power set by the user.

To set the value, run the poe max-power command.

POE Power Supply(mW)

PoE power supply, which is determined by the PoE power module configured on the device.

Available Total Power(mW)

Total available power.

Total Power Consumption(mW)

Total output power.

Power Peak Value(mW)

Peak value of the output power.

Power-Management Mode

Power management mode, including auto and manual modes.

To set the mode, run the poe power-management command.

Power High Inrush

State of power high inrush function, including enabled and disabled state. By default, the power high inrush function is in disabled state.

To set the state, run the poe high-inrush enable command.

Power AF Inrush

Whether to set the PoE standard to IEEE 802.3af.
  • enable: The current PoE standard is IEEE 802.3af.
  • disable: The current PoE standard is IEEE 802.3at.
By default, a central AP provides PoE power in compliance with IEEE 802.3at.

To configure this parameter, run the poe af-inrush enable command.

Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 212129

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next