No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
igmp-snooping enable (traffic profile view)

igmp-snooping enable (traffic profile view)


The igmp-snooping enable command enables IGMP snooping in a traffic profile.

The undo igmp-snooping enable command disables IGMP snooping in a traffic profile.

By default, IGMP snooping is disabled in a traffic profile.


igmp-snooping enable

undo igmp-snooping enable




Traffic profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

IGMP snooping is a basic Layer 2 multicast function that forwards and controls multicast traffic at the data link layer. IGMP snooping runs on a Layer 2 device and analyzes IGMP messages exchanged between a Layer 3 device and hosts to set up and maintain a Layer 2 multicast forwarding table. The Layer 2 device forwards multicast packets based on the Layer 2 multicast forwarding table.

After you disable IGMP snooping in a traffic profile using the undo igmp-snooping enable command, all IGMP snooping configurations on the device are deleted. When you run the igmp-snooping enable command to enable IGMP snooping again, all IGMP snooping configurations are restored to the default settings on the device.


The traffic profile has been created using the traffic-profile (WLAN view) command.

When multicast services are enabled, the multicast services may be affected if rate limit for multicast packets is enabled on an RU. In this case, you are advised to run the traffic-optimize broadcast-suppression rate-threshold (AP system profile view) command to adjust the rate limit threshold for multicast packets.


# Enable IGMP snooping in traffic profile p1.
<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] traffic-profile name p1
[Huawei-wlan-traffic-prof-p1] igmp-snooping enable
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 256350

Downloads: 144

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next