No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
eth-trunk

eth-trunk

Function

The eth-trunk command adds an interface to an Eth-Trunk.

The undo eth-trunk command removes an interface from an Eth-Trunk.

By default, an interface does not belong to any Eth-Trunk.

Format

eth-trunk trunk-id

undo eth-trunk

Parameters

Parameter

Description

Value

trunk-id

Specifies the ID of an Eth-Trunk interface.

The value is an integer that ranges from 0 to 7.

Views

GE interface view, XGE interface view

Default Level

2: Configuration level

Usage Guidelines

To improve the connection reliability and increase the bandwidth, you can use the eth-trunk command to bind multiple interfaces into an Eth-Trunk.

When you add an Ethernet interface to an Eth-Trunk, the interface must use the default settings of certain attributes. Otherwise, the interface cannot be added to the Eth-Trunk. The attributes that use the default settings include:

  • Link type
  • VLAN that the interface belongs to
  • Interface priority
  • Whether the interface allows BPDUs to pass through
  • MAC address learning
  • Adding the interface to a multicast group statically
  • Discarding broadcast packets
  • Discarding unknown multicast packets
  • Discarding unknown unicast packets

Those attributes must remain consistent and cannot be changed individually. If the preceding attributes of an Eth-Trunk are changed, the attributes of all the member interfaces are changed accordingly.

It is recommended that you run the shutdown (interface view) command to disable an interface before adding the interface to an Eth-Trunk. After adding interfaces at both ends of a link to an Eth-Trunk, run the undo shutdown (interface view) command to enable the interfaces. Otherwise, traffic interruption or broadcast storms may occur.

It is recommended that you run the shutdown (interface view) command to disable a member interface before running the undo eth-trunk command to remove the member interface from an Eth-Trunk.

The number of member interfaces of the Eth-Trunk on devices at both ends must be equal. The interfaces at both ends must be connected with straight-through cables.

Example

# Add GigabitEthernet0/0/1 to Eth-Trunk 2.

<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/1
[Huawei-GigabitEthernet0/0/1] eth-trunk 2
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 203795

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next