No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
damping time

damping time

Function

The damping time command sets the VLAN damping time on a VLANIF interface, that is, the delay before reporting a VLAN Down event to the VLANIF interface.

The undo damping time command restores the default dumping time.

The default damping time on a VLANIF interface is 0 seconds. That is, the VLANIF interface is notified immediately after the VLAN becomes Down.

Format

damping time delay-time

undo damping time

Parameters

Parameter

Description

Value

delay-time

Specifies the delay before reporting the VLAN Down event to a VLANIF interface.

The value ranges from 0 to 20, in seconds. The default value is 0.

Views

VLANIF interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Software upgrade or active/standby switchover on the wireless access point may cause frequent status changes on VLANIF interfaces. To prevent network flapping, run the damping time command on VLANIF interfaces to configure the VLAN damping function.

When all interfaces in a VLAN become Down, the wireless access point waits for a period specified by delay-time and then reports the VLAN Down event to the VLANIF interface.

Precautions

If any interface in the VLAN becomes Up within the delay time, the VLANIF interface remains Up.

You can use the display interface vlanif command to view the VLAN damping time.

If you run the damping time command multiple times in the same VLANIF interface view, only the latest configuration takes effect.

Example

# Set the VLAN damping time on VLANIF 10 to 10 seconds.

<Huawei> system-view
[Huawei] vlan 10
[Huawei-vlan10] quit
[Huawei] interface vlanif 10
[Huawei-Vlanif10] damping time 10
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 201858

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next