No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The mode command configures the working mode of an Eth-Trunk.

The undo mode command restores the default working mode of an Eth-Trunk.

By default, an Eth-Trunk works in manual load balancing mode.


mode manual load-balance

undo mode


Parameter Description Value
manual load-balance Indicates the manual load balancing mode. -


Eth-Trunk interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenarios

Currently, the device supports Eth-Trunks to work in the following modes:
  • Manual load balancing mode

    When one of the devices at the two ends of an Eth-Trunk link does not support LACP, you can run the command to configure the Eth-Trunk interface to work in manual load balancing mode. In addition, you can add multiple member interfaces to increase the bandwidth between the two devices and improve reliability.

    The manual load balancing mode is a basic link aggregation mode. In this mode, you must manually create an Eth-Trunk interface, add interfaces to the Eth-Trunk interface. LACP is not involved.

    In manual load balancing mode, all active member interfaces forward data and perform load balancing.


If you run the mode command multiple times, only the latest configuration takes effect.


# Configure Eth-Trunk 1 to work in manual load-balance mode.

<Huawei> system-view
[Huawei] interface eth-trunk 1
[Huawei-Eth-Trunk1] mode manual load-balance
Related Topics
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 194982

Downloads: 118

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next