No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
power auto-adjust enable

power auto-adjust enable

Function

The power auto-adjust enable command enables signal-strength-based power adjustment for APs.

The undo power auto-adjust enable command disables signal-strength-based power adjustment for APs.

By default, signal-strength-based power adjustment is disabled for an AP.

Format

power auto-adjust enable

undo power auto-adjust enable

Parameters

None

Views

2G radio profile view, 5G radio profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The traditional radio power control function sets the power of an AP to a fixed value to keep the power of all STAs connecting to the AP the same.

You can run the power auto-adjust enable command to enable signal-strength-based power adjustment. This function enables an AP to detect the signal strength of a STA in a timely manner. If the AP detects that the signal strength of the STA is strong (for example, the STA is near the AP), the AP reduces its transmit power when sending packets. If the AP detects that the signal strength of the STA is weak (for example, the STA is far from the AP), the AP uses the normal transmit power to send radio signals.

Prerequisites

The power mode has been set to automatic mode using the undo calibrate auto-txpower-select disable command.

Example

# Enable signal-strength-based power adjustment for APs.

<Huawei> system-view
[Huawei] wlan 
[Huawei-wlan-view] radio-2g-profile name huawei
[Huawei-wlan-radio-2g-prof-huawei] power auto-adjust enable
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 200528

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next