No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
poe { power-off | power-on } interface

poe { power-off | power-on } interface


The poe { power-off | power-on } interface command manually powers on or powers off the PD of an interface.

Only the AP8082DN, AP8182DN, AP4050DN-E, AP4050DN-HD, AP7050DN-E, AD9431DN-24X, AD9430DN-24, and AD9430DN-12 support this command.


poe { power-off | power-on } interface interface-type interface-number






Powers off an interface.



Powers on an interface.


interface-type interface-number

Specifies the type and number of the interface that needs to be powered on or powered off manually.



System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenarios

In manual power management mode, run the poe { power-off | power-on } interface command to power on or power off interfaces. To check whether the command runs successfully, run the display poe power-state command.


When the available power of the device is insufficient and the device cannot provide power for a new PD, the poe power-on interface command is invalid.

Pre-configuration Tasks

Before powering on or powering off an interface, ensure that:

  • The power management mode has been in manual mode through running the poe power-management command.

  • PDs have been connected to the interface.

  • The PoE function of the interface has been enabled.

  • The classification of the PDs connected to the interface has finished and the PDs have been ready for being powered on.


# Manually power on GigabitEthernet0/0/1 interface.
<Huawei> system-view
[Huawei] poe power-on interface gigabitethernet 0/0/1
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 247508

Downloads: 140

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next