No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
user-isolate (AP wired port profile view)

user-isolate (AP wired port profile view)


The user-isolate command enables user isolation on an AP's wired interface.

The undo user-isolate command disables user isolation on an AP's wired interface.

By default, user isolation is disabled on an AP's wired interface.


user-isolate { all | l2 }

undo user-isolate






Enables Layer 2 and Layer 3 user isolation.



Enables Layer 2 user isolation.



AP wired port profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The user isolation function prevents users on the same wired interface from communicating with each other. All user traffic on the wired interface is forwarded by the gateway. Therefore, this function ensures communication security on wired interfaces and allows uniform charging for users.


Eth-Trunk member interfaces do not support the user isolation function.

The AP's wired interface has been configured to work in endpoint or middle mode.


# Set the working mode of the AP's wired interface GE0 to endpoint and enable Layer 2 user isolation on GE0.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] ap-group name ap-group1
[Huawei-wlan-ap-group-ap-group1] quit
[Huawei-wlan-view] wired-port-profile name wired
[Huawei-wlan-wired-port-prof-wired] mode endpoint
Warning: If the AP goes online through a wired port, the incorrect port mode configuration will cause the AP to go out of management
. This fault can be recovered only by modifying the configuration on the AP. Continue? [Y/N]:y
[Huawei-wlan-wired-port-prof-wired] user-isolate l2
[Huawei-wlan-wired-port-prof-wired] quit
[Huawei-wlan-view] ap-group name ap-group1
[Huawei-wlan-ap-group-ap-group1] wired-port-profile wired gigabitethernet 0
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 206168

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next