No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ip-address (AP provisioning view)

ip-address (AP provisioning view)


The ip-address command configures a static IPv4 address and gateway for an RU.

The undo ip-address command restores the default static IPv4 address and gateway for an RU.

By default, no static IPv4 address and gateway are configured for an RU.


ip-address ip-address { mask-length | mask } [ gateway gateway ]

undo ip-address


Parameter Description Value
ip-address Specifies the static IPv4 address for an RU.

The value is in dotted decimal notation.

mask Specifies the IPv4 address mask for an RU.

The value is in dotted decimal notation.

mask-length Specifies the IPv4 address mask length for an RU. The value is an integer that ranges from 0 to 32.
gateway gateway Specifies the egress gateway for RU routes.

The value is in dotted decimal notation.


AP provisioning view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the ip-address command to configure a static IPv4 address for an RU.


The RU has been configured to obtain an IP address in static mode using the address-mode (AP provisioning view) command.

Follow-up Procedure

Run the commit command to deliver configuration to RUs and restart the RUs to make the configuration take effect.


CAPWAP packets between the central AP and RUs are forwarded at Layer 2 and are independent of IP addresses. Therefore, the configuration of a static IP address does not affect the RU going online. Ensure that a route is reachable between the IP address of the RU and the central AP source address. Otherwise, services involving IP addresses may be affected, for example, Telnet.


# Set the static IPv4 address of the RU to

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] provision-ap
[Huawei-wlan-provision-ap] address-mode static
[Huawei-wlan-provision-ap] ip-address 24
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 207953

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next