No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
redirect-acl

redirect-acl

Function

The redirect-acl command configures the ACL used for redirection in a service scheme.

The undo redirect-acl command deletes the ACL used for redirection in a service scheme.

By default, no ACL for redirection is configured in the service scheme.

Format

redirect-acl { acl-number | name acl-name }

undo redirect-acl

Parameters

Parameter Description Value
acl-number

Specifies the number of the ACL used for redirection.

The value ranges from 3000 to 3031, and it must exist.

name acl-name

Specifies the name of the ACL used for redirection.

The ACL name must exist. The length ranges from 1 to 32.

Views

Service scheme view

Default Level

3: Management level

Usage Guidelines

Usage Scenario

In some authentication scenarios, after users succeed in authentication, the administrator needs to redirect HTTP/HTTPS traffic matching ACL permit rules to the Portal authentication page where users are authenticated again.

Precautions

Before running this command, you are advised to run the acl (system view) or acl name command to create an ACL.

If the ACL is not created before and after this command is run, the redirection ACL will fail to be delivered.

To redirect HTTPS traffic, run the portal https-redirect enable (Cloud AP) command to configure the HTTPS redirection function.

Example

# Configure ACL 3001 for redirection in the service scheme svcscheme1.

<Huawei> system-view
[Huawei] acl 3001
[Huawei-acl-adv-3001] quit
[Huawei] aaa
[Huawei-aaa] service-scheme svcscheme1
[Huawei-aaa-service-svcscheme1] redirect-acl 3001
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 204466

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next