No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
port hybrid untagged vlan

port hybrid untagged vlan


The port hybrid untagged vlan command adds a hybrid interface to the specified VLANs. Frames of the VLANs then pass through the hybrid interface in untagged mode.

The undo port hybrid vlan command removes a hybrid interface from the specified VLANs.

By default, a hybrid interface is added to VLAN 1 in untagged mode.


port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }

undo port hybrid vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }





vlan-id1 [ to vlan-id2 ]

Adds a hybrid interface to specified VLANs.
  • vlan-id1 specifies the start VLAN ID.
  • to vlan-id2 specifies the end VLAN ID. The value of vlan-id2 must be greater than or equal to the value of vlan-id1.

The value of vlan-id1 is an integer that ranges from 1 to 4094.

The value of vlan-id2 is an integer that ranges from 1 to 4094.


Adds a hybrid interface to or deletes it from all VLANs.



GE interface view, Eth-Trunk interface view, XGE interface view, MultiGE interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

A hybrid interface can connect to either a user device or a wireless access point. When a hybrid interface is connected to a user device, it must be added to VLANs in untagged mode so that it sends untagged frames.

After a hybrid interface is added to VLANs in untagged mode, the interface removes VLAN tags of frames before sending frames.


If an interface is not a hybrid interface, run the port link-type hybrid command to change the interface type to hybrid.


If you run the port hybrid untagged vlan command multiple times in the same interface view, the interface is added to all the specified VLANs.


# Add GE0/0/1 to VLAN 3 to VLAN 5 in untagged mode.

<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/1
[Huawei-GigabitEthernet0/0/1] port link-type hybrid
[Huawei-GigabitEthernet0/0/1] port hybrid untagged vlan 3 to 5
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 198937

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next