No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
stp auto-shutdown recovery-time (AP wired port profile view)

stp auto-shutdown recovery-time (AP wired port profile view)

Function

The stp auto-shutdown recovery-time command sets an auto-recovery interval for an AP's wired interface on which the STP-triggered port shutdown function is enabled.

The undo stp auto-shutdown recovery-time command restores the default auto-recovery interval for an AP's wired interface on which the STP-triggered port shutdown function is enabled.

By default, the auto-recovery interval is 600s.

Format

stp auto-shutdown recovery-time recovery-time

undo stp auto-shutdown recovery-time

Parameters

Parameter

Description

Value

recovery-time

Specifies the auto-recovery interval for an AP's wired interface on which the STP-triggered port shutdown function is enabled.

The value is an integer that ranges from 600 to 3600, in seconds.

Views

AP wired port profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After the STP-triggered port shutdown function is enabled, the AP automatically shuts down the interface when STP detects a loop. The RU will periodically recover the interface and re-executes STP detection. If the loop still exists on the interface, the AP shuts down the interface again. If the loop is removed, the AP reports a clear alarm to the network management system (NMS).

Prerequisites

The STP-triggered port shutdown function has been enabled on the AP's wired interface using the stp auto-shutdown enable (AP wired port profile view) command.

Precautions

The AP wired interfaces added to an Eth-trunk interface do not support this function.

Example

# Set the auto-recovery interval to 800s for an AP's wired interface on which the STP-triggered port shutdown function is enabled.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] wired-port-profile name wired
[Huawei-wlan-wired-port-prof-wired] stp auto-shutdown recovery-time 800
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 202907

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next