Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STP/RSTP/MSTP Configuration Commands
- active region-configuration
- check region-configuration
- display stp
- display stp abnormal-interface
- display stp active
- display stp bridge
- display stp error packet
- display stp global
- display stp region-configuration
- display stp tc-bpdu statistics
- display stp topology-change
- display stp vlan
- instance
- max bandwidth-affected-linknumber
- region-name
- reset stp error packet statistics
- reset stp statistics
- revision-level
- stp bpdu-filter
- stp bpdu-filter default
- stp bpdu-protection
- stp bridge-diameter
- stp compliance
- stp config-digest-snoop
- stp converge
- stp cost
- stp edged-port
- stp edged-port default
- stp enable
- stp loop-protection
- stp max-hops
- stp mcheck
- stp mode (system view)
- stp no-agreement-check
- stp pathcost-standard
- stp point-to-point
- stp port priority
- stp priority
- stp region-configuration
- stp root
- stp root-protection
- stp tc-protection
- stp tc-protection interval
- stp tc-protection threshold
- stp timer forward-delay
- stp timer hello
- stp timer max-age
- stp timer-factor
- stp transmit-limit (interface view)
- stp transmit-limit (system view)
- vlan-mapping modulo
Previous
