port-isolate mode
Function
The port-isolate mode command sets the port isolation mode.
By default, ports are isolated at Layer 2 but can communicate at Layer 3.
Only the AD9431DN-24X supports this function.
Usage Guidelines
Usage Scenario
To disable members in a port isolation group from communicating at Layer 2 but allow them to access public resources, such as printer and server, run the port-isolate mode command to set the port isolation mode to l2.
To disable members in a port isolation group from communicating at both Layer 2 and Layer 3, run the port-isolate mode command to set the port isolation mode to all.
Precautions
To isolate ports at both Layer 2 and Layer 3, run the port-isolate mode all command.
To isolate ports at Layer 2 but allow them to communicate at Layer 3, run the port-isolate mode l2 command.
Previous
